Exit comparison view by clicking on the comparison view button in either location.This will match the current clip to the reference by altering the color wheels.Click on the apply match button in the Color Wheels & Match section.Select the reference clip on the left by using the scrubber, the arrows or the timecode under the reference side. Enter comparison view mode by clicking the comparison view button in the program monitor button bar or in the Color Wheel & Match section.Park the playhead on the clip that needs some color correction (it should get automatically selected).I recommend using the Color workspace because it enables "Selection follows playhead" which will ensure that you always have the clip under the playhead selected.Īs a recap, these are the steps to successfully use Color Match It sounds to me like some users do not have the "Current" clip selected, which could definitely yield these results. To sum up, don't select your reference frame form a single clip, but navigate to it from within the comparison view window which gives you access to the entire sequence. By doing this, then clicking the Apply Match button, I no longer got the infinite "analyzing" problem. From here, go to the Color Wheels and Match section, click Comparison view, and from the comparison view window, select the reference frame using the slider bar. The solution seems to be to select the Lumetri Color tab listed under the Effects view, located on the right hand side of my setup. What I was doing wrong it seems, was selecting my reference clip in the timeline, ie, whatever the first frame of the selected clip was, and proceeding from there. By approaching my color matching from this angle, I was experiencing the same "analyzing" hang up that others experienced here. From there, under Color Wheels and Match section, I was clicking on the Comparison View and Apply Match buttons. I first encountered this problem by selecting a clip in the timeline, then selecting that clip's lumetri effect (which I had applied earlier) under the effects controls tab for that clip. However for my case in the end I do not see the background layer which I should see after deleting the unecessary light peach color around the face.īelow is the image of my screen and you can see the issue I have with a white color coming out of nowhere after I use the selection tool.I may have found the solution to this problem. If my explanation is hard to understand or visualize, what I am trying to do is in this tutorial video from timestamp 9:21-10:08 What I should be seeing is the light grey background behind the colored face however I see a white background? I then go back into the skin coloring layer and delete the light peach color from the background leaving it only on the face. I then go into my lineart layer and use the Contiguous selection tool to select the layer so it scans the face. I use a bucket and color the whole layer a light peach. I start by creating a new paint layer under my lineart to be the skin coloring layer. So I am learning how to color with krita and I first have my line art layer of a characters face, then I have my background layer that is light grey.
0 Comments
Leave a Reply. |